- Testout lab install and configure 4.8.6 pdf#
- Testout lab install and configure 4.8.6 manual#
- Testout lab install and configure 4.8.6 password#
- Testout lab install and configure 4.8.6 Pc#
Testout lab install and configure 4.8.6 password#
S1(config)# line console 0 S1(config-line)# password cisco S1(config-line)# login S2(config)# line console 0 S2(config-line)# password cisco S2(config-line)# login Assign cisco as the console password and enable login. S1(config)# enable secret class S2(config)# enable secret classį. Assign class as the privileged EXEC encrypted password. S1(config)# no ip domain-lookup S2(config)# no ip domain-lookupĮ.
Disable DNS lookup to prevent the router from attempting to translate incorrectly entered commands as though they were host names. switch(config)# hostname S1 switch(config)# hostname S2ĭ. Console into the switch and enable privileged EXEC mode. Step 2: Configure basic settings for each switch.Ī. Step 1: Cable the network as shown in the topology.Īttach the devices as shown in the topology diagram, and cable as necessary.
Testout lab install and configure 4.8.6 Pc#
In Part 1, you will set up the network topology and configure basic settings on the PC hosts and switches.
2 Switches (Cisco 2960 with Cisco IOS Release 15.2(2) lanbasek9 image or comparable).
Testout lab install and configure 4.8.6 manual#
Instructor Note: Refer to the Instructor Lab Manual for the procedures to initialize and reload devices. If you are unsure contact your instructor. Note: Ensure that the routers and switches have been erased and have no startup configurations. Refer to the Router Interface Summary Table at the end of the lab for the correct interface identifiers. Depending on the model and Cisco IOS version, the commands available and the output produced might vary from what is shown in the labs. Other routers, switches, and Cisco IOS versions can be used. Note: The switches used with CCNA hands-on labs are Cisco Catalyst 2960s with Cisco IOS Release 15.2(2) (lanbasek9 image). In this lab, you will create VLANs on both switches in the topology, assign VLANs to switch access ports, verify that VLANs are working as expected, and then create a VLAN trunk between the two switches to allow hosts in the same VLAN to communicate through the trunk, regardless of which switch the host is actually attached to. Trunks allow the traffic from multiple VLANS to travel over a single link, while keeping the VLAN identification and segmentation intact. VLAN trunks are used to span VLANs across multiple devices. In general, VLANs make it easier to design a network to support the goals of an organization. VLANs can also be used as a security measure by controlling which hosts can communicate. Modern switches use virtual local-area networks (VLANs) to improve network performance by separating large Layer 2 broadcast domains into smaller ones.
Testout lab install and configure 4.8.6 pdf#
0 kommentar(er)
